Instead of using sparse module space in the rack, I have made a handfull of cables with “in-line” small potentiometers. I find it strange that cables like these cannot be found
This is basically just a 3D-printed frontpanel for a Raspberry Pi 4, with all necessary I/O brought to the front. The panel is comprised of 4 parts, 2 backsides and
A little update with a few sound examples. I finally finished recreating my lost synth, and as you can see: Large components, analog stuff all over, and as some would
I saw the Willem Twee Studios! A little intro: I have followed Hainbach on YouTube since he started in his living room, mainly because he makes really good music, but
While all world was in corona lockdown I worked on a new series of Eurorack modules. One goal was to make four sets of modules, and each set should be
Most commercially available analog sequencers are rather expensive and take up a lot of space. Since I am only interested in having a small rack for testing modules that I
I made a simple Excel-tool to document resources and cable patching on my Eurorack Synth. With a modular synth it can be difficult to recreate a nice cool sound after
My latest module for spring reverb is heavily inspired by the good advice you can find on Rod Elliot, ESP . My own contribution is that I have made it a
Can you guess the purpose of the component shown above? Four wires goes into the glass bulb. From the tip of each wire, very thin wires connect to a
This module is a very simple mixer: 7 inputs 7 potentiometers Linear potentiometers also mix CV-signals Two summing ‘op-amps’ With two outputs used Four upper inputs go to the
